We are featuring nos items too ! Take a look !
This is the metering rod gauge !
It must be used to adjust the carburator.
With shoulder on metering rod seated in metering rod jet, metering rod pin must be adjusted to lightly contact top of metering rod eyelet with .015” to .016” opening between edge of throttle valve and bore of carburator. Correct setting of metering rod is omportant and must be made after pump adjustment. Install metering pin and spring assembly, washer and nut loosely on pump operating lever. The gauge must be inserted in the place of metering rod , seated tapered end in metering rod jet. Hoòd gauge vertical to insure seating. With throttle valve seated, push metering rod pin downward until pin rests on shoulder of natch in gauge and tighten nut. Remove gauge and install metering rod, disc and pin spring. Connect metering rod spring.
Posted on 27.08.07
